Wurth 0890321 ENGINE SEALING COMPOUND SILICONE SPECIAL 250 70ml

• Excellent sealing ability thanks to permanently plastic (non-hardening) properties
• Resistance to vibration guaranteed even after years of exposure
• No pulling of threads during application
• Does not run on vertical or downward-sloping surfaces
• Temperature-resistant from -50°C to +270°C; for brief periods up to +300°C
• Poor thermal conductivity
• Does not bond to metals or other materials chemically, prevents atmospheric corrosion
• Resistant to water, air, gasoline, kerosene, a variety of oils, synthetic lubricants, water/glycol and methanol mixtures, anti-freeze, fluorocarbon cooling agents
• Silicone-free
• Non-toxic

NSF registered, class P1, reg. no. 151822 The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Excellent resistance to chemicals

• Can also be used in critical areas in which the seal comes into contact with various liquids
• Outstanding resistance to engine oil and transmission oil, refrigerant and anti-freeze agent

 

Non-acidic hardening system

• Non-corrosive, therefore has no negative impact on electronic components and on lambda probes

 

Sealant in compressed-air can

• Easy to dispense without additional aids
• The fine beads allow the product to be applied uniformly

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage and processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Single flat blade available in 10 lengths

 

97% market coverage

Thanks to the availability of adapters for all conventional OE interfaces

Easier installation

• "Click in" function
• The adapters are numbered for quicker identification

 

Optimal properties, even at high speeds (>130 km/h)

• Symmetrical spoiler
• Nano coating

 

Good wind resistance

Slimline design allows a good fit to the windscreen  

Refillable (replacement rubber wiper blade)

Environmentally friendly replacement of worn rubber parts

Prevents deposits from building up in the combustion chamber and injection system

• Improves the lubricating effect of low-sulphur fuels

Therefore prevents surface abrasion and prevents the risk of the injection system malfunctioning.

• The storage stability of bio-diesel fuels is extended

Ensures precise diesel injection

• Lower fuel consumption
• Quiet engine running

 

Free from sulphur, phosphorous, metals and acids

Economical

300 ml is sufficient for 70 litres of diesel.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.