Multipurpose motor oil additive. Atomic metal conditioner for diesel truck engines. Contains nanocomponent REVITALIZANT®.
The product is specially developed for turbocharged diesel engines (SHPD – Super High Performance Diesel, UHPD – Ultra High Performance Diesel) and is used for their active protection through high-speed and loaded operating modes.
XADO HighWay for diesel truck is an innovative 3-component product of a new generation that combines the advantages of a two-phase complex metal conditioner and nanocomponent REVITALIZANT® (RF = 5.5) *.
* RF (REVITALIZATION® factor) – efficiency index for engine restoration and wear protection. RF = 5.5 means that the engine is reliably protected from continued wear.
The action of the product is complex; due to the presence of a REVITALIZANT® nanocomponent, the modification of the friction surfaces of engine parts takes place directly during operation (a protective ceramic-metal layer is formed). The complex metal conditioner strengthens the lubricating oil film and reduces frictional losses.
Compensates for continued wear of friction parts.
It reduces frictional losses, thereby increasing engine power and acceleration.
It also creates an active system to protect parts from loads and overheating.
Improves the lubricating properties of the oil and the tribological characteristics of the motor units.
Contributes to the reduction of fuel consumption.
Increases expected engine life.
the product can also be used for off-road vehicle engines, buses, marine diesel engines, diesel generators, etc.
the product is compatible with all types of motor oils;
for a better effect, it is recommended to use XADO HighWay for diesel fuel at each engine oil change;
for complete REVITALIZATION® of the engine and in order to ensure the highest possible level of anti-anti-protection, it is recommended to use XADO Maximum for a diesel truck (RF = 100 RF) once every 100,000 km.
the product contains REVITALIZANT® in granules that completely dissolve in the oil at operating temperature.
The temperature of the product before application should not be lower than + 25 ° C. Shake the bottle. Place its contents in the oil filler neck of the engine warmed to operating temperature. Start the engine and let it idle for 3-5 minutes. Run the engine in normal mode.
1 bottle (950 ml) for an engine with an oil system capacity of 30-45 L.
Attention! The oil level should not exceed the maximum mark. Avoid overdose.