Motor oil XADO XA 20104 10W60 SL/CF Rally Sport 5l

Atomic Metal Conditioner Maximum with 1 Stage Revitalizant is an innovative 3-component product specially formulated for treating vital engine parts in cars with oil system capacity up to 5 qt. Due to Revitalizant the product reduces friction, rebuilds worn metal in engine parts and creates protective coating against future wear, thus providing tools-free restoration and anti-wear protection. Product application prolongs the life of your engine and allows avoiding expensive repairs in the future. One treatment lasts for 60,000 miles! Application Make sure the automobile engine is warmed up to normal operating temperature. Turn off the vehicle. Shake the bottle for one minute and ensure it is at room temperature so that contents flow freely. Pour the contents into the engine oil reservoir. Start the car and let the engine idle for five minutes. Then drive as you normally would. It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended. Granules of Revitalizant completely dissolve in motor oil at normal operating temperature. 1 Bottle (225 ml) of Atomic Metal Conditioner is enough for engine with an oil capacity of 5 qt. Larger vehicles with higher oil capacities may require more. Note Atomic Metal Conditioner Maximum with 1 Stage Revitalizant works in all gasoline-powered, natural-gas and diesel engines of passenger cars and trucks and 4-stroke motorcycles with oil system up to 5 Quarts Can be combined with all types of motor oils, from full synthetic to mineral oils It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended Repeated application of Atomic Metal Conditioner Maximum is recommended after 60,000 miles For the highest level of protection for your vehicle’s engine use XADO Atomic Oil or Atomic Metal Conditioner HighWay during each oil change in the future. AMC Highway contains 5.5% (RF5.5) of the active ingredient necessary for 1 complete revitalization cycle Technology and certificates TUV 3C EFFECT 3G generation 100 000 re-treatment interval Rebuilds worn engine metal and reverses metal wear Increases power and acceleration Reduces fuel consumption Increases engine cylinders’ compression Decreases noise and vibrations Restores lost oil pressure up to nominal level Protects metal parts from overheating and overloading Improves oil lubricating properties and tribological characteristics of engine parts Increases engine service life Reduce exhaust emissions toxicity (CO2, CO, HC) One treatment lasts for 60,000 miles

ATOMEX DIESEL F8 COMPLEX IS A PRODUCT DESIGNED TO PROTECT DIESEL ENGINE AGAINST LOW-QUALITY FUEL. Improves the properties of low-quality fuel up to the level of brand marks. Insures engine operation on standard gasoline as if on sport gasoline. Reliably protects fuel system when using low-quality fuel. Even a single fueling with low-quality fuel may result in unstable operation and hampered engine start, clogging of fuel system, power decrease and fuel consumption increase. In some cases this cause failure of fuel equipment and sealing of a catalyst. Solution: application of the product, which eliminates negative effects of operation on low-quality fuel. Fueling with contaminated fuel and accidental water entry may cause breakdown of a high pressure fuel pump (wedging). Solution: revitalizant contained in the product will reliably protect fuel equipment parts, pump and plungers from wear. Ensures smooth and frictionless engine operation on fuel of any quality Reliably protects fuel system after accidental fueling Efficiently cleans all parts of the fuel system Improves fuel quality Removes moisture from diesel fuel Contributes to fuel economy Prevents early breakage of a particulate filter Due to the revitalizant, AtomEx F8 Complex Formula: Forms firm antiwear coating on the fuel equipment parts directly during the mechanism operation Restores pump* performance to the nominal level and improves fuel dispersion Protects plunger pistons during operation on low-quality fuel Increases performance reliability and extends service life of fuel system parts *tested for Common-Rail service systems (of the accumulator type) and Pumpe-Düse (pump-injector unit) APPLICATION INSTRUCTIONS Pour the product into a fuel tank before fueling NOTE The product is compatible with diesel fuel of all types, safe for particulate filters, catalyst converters and valves. Apply if necessary. Can be applied with every fueling. DOSAGE 250 ml of product for 40-60 L of fuel. PACKAGE Aerosol can 250 ml XA 40213

REVITALIZANT® EX120 for diesel engines. EX120 Revitalizant is designed to restore, repair and protect all diesel engines. including high-powered and turbocharged engines, against metallic wear and tear. The gel forms a new cermet coating on friction surfaces (the engine parts grow in volume, restore their original geometry). As a result a renovated unit exceeds the performance level of a new one and will last 2-4 times longer. General characteristics of the cermet layer: microhardness – 750 kg/mm2 high corrosion resistance roughness Ra up to 0,06 mkm Application: Processing of the engine with the oil system 3-10 liters. Step 1: Squeeze out the contents of one tube of EX120 Revitalizant into the oil filer of the engine warmed up to the running temperature. Start the engine and let it idle run for 5-10 minutes. Step 2: Repeat the Step 1 after 62-155 miles. Step 3: Repeat the Step 2 after 62-155 miles. The treatment is complete after ~1,000 miles Dosage: Oil system volume, L 3-10 11-20 21-30 Tubes, pcs 3 6 9 Treatment scheme 1+1+1 2+2+2 3+3+3 Tubes for new engines 2 4 6 Note! Do not change the oil until thetreatment has finished New engines with less than 20,000 km (12,500 miles) of run should be treated in one go Revitalization is considered to be completed after approx 1,000 miles The treatment can be applied when the engine is idling (4 hours idling is equivalent to 124 miles) Overhauled engines should be treated in 3 stages according to the normal procedure. New engines should be treated in one step – 2 tubes at one time The protective cermet coating forms on any working mechanism; if the mechanism (engine) is in a badly worn state, the worn parts should be replaced Capability: During the engine operation cylinder piston group in area of upper “blind” spot, the details of Variable Valve Event and Lift (VVEL), slider bearer of bent and countershaft. Revitalizant contains constructional material which takes up the wear of details. Due to revitalization on the surface of friction pair a new multifunction gradient covering is formed with the number of necessary character rating and strenuous conditions. The details of the engine increase in volume by returning everything that was worn in the process of exploitation. This is an effect of repairmen. Obtained cover has unique properties: more solid, corrosionproof, low gritness. After revitalization details of engine reliably will serve up to 2-4 times longer. This is an effect of protection from wearing-out. Due to revitalization of an engine significantly increases and aligns compression in cylinder, reduces fuel consumption, increases adhesion and coasting of car, restores of oil pumps, turbo sites, axles and linings, cylinder bearing surfaces, removes ovality. An engine will work quietly and without any vibration. Due to revitalization it can be kept in a perfect condition. Technology and certificates 2G generation Restores and protects friction parts of the cylinder-piston group, crank and gas distributing mechanisms against wear-out Significantly reduces fuel consumption (up to 30% at idle run) Increases oil pressure to the nominal Regains and increases compression in cylinders Increases engine power, improves acceleration capability Decreases noise and vibration level up to 10 times Increases service life of the units up to 2-3 times Protects an engine from negative consequences of “cold” start Improves engine operation after 31-62 mi Maintains engine operation during 186 mi in case of oil leakage

XADO 1 Stage New Car Metal Conditioner provides top level of engine protection of a new car and local accurate adjustment of parts to each other during running-in. Innovative 3-component product of new generation that combines advantages of two-phase complex metal conditioner and revitalizant of the third generation. Specially designed for new gasoline, LPG and diesel engines (with mileage up to 12,427 mi). Application: The temperature of the product should be at least 25° C (77 F) Shake the bottle. Pour the content of the bottle into the oil filler of the engine warmed up to the working temperature. Start the engine and let it idle run for 3 to 5 minutes Notes! XADO 1 Stage Atomic Metal Conditioner with revitalizant is effective for gasoline, LPG and diesel engines of passenger cars and small trucks with oil system up to 10 L Compatible will all types of motor oils Revitalization is completed within 621-932 mi; it is not recommended to change oil during this time. To keep the highest protection level of the engine from wear-out it is recommended to use XADO Atomic Oil or XADO HighWay Metal Conditioner during each oil change in future *The product contains revitalizant in granules which is fully dissolved in the oil at working temperature. Package: Bottle 225 ml XA 40011 Bottle 225 ml compact package XA 40211 Gift set: bottle 225 ml, USB flash drive XA 40311 Gift set: bottle 225 ml, keychain 40411 Technology and certificates 3C EFFECT 3G generation Ensures accurate adjustment of parts of a new engine during running-in Compensates parts for wear-out during operating Creates active protection system of parts from loads and overheating Improves lubricating properties of oil and tribological characteristics of engine units Reduces fuel consumption Increases power and acceleration capability Decreases noise and vibration level Increases engine resource Guarantees wear-out protection of the engine for 62,137 mi RF=100 RF (Revitalization factor) is an efficiency index of restoration and protection of the engine against wear-out. RF=100 stands for a complete revitalization cycle and guarantees wear-out protection for 62,137 mi.