Wurth 090320 Manual mounting pliers

Excellent resistance to chemicals

• Can also be used in critical areas in which the seal comes into contact with various liquids
• Outstanding resistance to engine oil and transmission oil, refrigerant and anti-freeze agent

 

Non-acidic hardening system

• Non-corrosive, therefore has no negative impact on electronic components and on lambda probes

 

Sealant in compressed-air can

• Easy to dispense without additional aids
• The fine beads allow the product to be applied uniformly

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage and processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Single flat blade available in 10 lengths

 

97% market coverage

Thanks to the availability of adapters for all conventional OE interfaces

Easier installation

• "Click in" function
• The adapters are numbered for quicker identification

 

Optimal properties, even at high speeds (>130 km/h)

• Symmetrical spoiler
• Nano coating

 

Good wind resistance

Slimline design allows a good fit to the windscreen  

Refillable (replacement rubber wiper blade)

Environmentally friendly replacement of worn rubber parts

For cleaning the injection pump and nozzle

• Loosens and removes deposits, even in micro range
• Ensures clean combustion

 

Neutralises and binds acid condensation water

• Protects the fuel system from corrosion
• Cleans and protects from the tank through to the combustion chamber

 

Improves cetane number and reduces fuel-related “knocking”

 

Active agent concentrate based on synthetic components, as used in national and international diesel fuels.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Cleans the inside of the engine and the oil supply system

Engines cleaned of dirt can now operate at their full performance level together with the clean oil.

• Quick and gentle cleaning process
• Does not attack seals
• Optimise exhaust gas emissions
• Compatible with catalytic converters
• Loosens jammed piston rings
• Easy to use
• A 400 ml can is sufficient for up to 5 litres of engine oil. 1000 ml is sufficient for 10–15 litres of oil

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.