VITESCO A2C9135660077 NOx Sensor, urea injection

For high-strength connection of cylindrical parts subject to high loads Reliable hardening at low temperatures around 0°C A reliable "helper" in winter, too High degree of gap bridging Completely fills extensive surface roughnesses Gap filling capacity of 0.15 mm Even extremely large deviations are cost effective to correct. Prevents frictional corrosion The bearings will not seize up. Resistant to a large number of bases, gases, solvents, oils and fuels Silicone-free, solvent-free and oil-free DOS system: Practical one-handed operation thanks to the clever turn lock One hand always remains free. Continuously adjustable dispensing system Dispensing can be adjusted to suit the application, and to keep consumption and costs to a minimum. No residue material in dispensing neck Costs optimised thanks to emptying with virtually no remaining product Notice The following plastics can be affected in the event of prolonged exposure: ABS, celluloid, polystyrene, polycarbonate (Macrolon), PMMA (Plexiglas), polysulfone, SAN (lurane, Tyril), Vinidur, vulcanised fibre, and painted surfaces. We always recommend that you conduct your own tests. NSF-registered, Class S5, bearing retaining compound NSF-tested in accordance with NSF/ANSI 61 for use in service water and drinking water up to +82°C The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. If our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products. Please observe the technical data sheet! Weight of content 25 g Chemical basis Methacrylic acid ether Colour Green Density/conditions 1.07 g/cm³ / in accordance with DIN EN ISO 2811-1 Suitable for max. thread M12 Max. gap-filling ability 0.15 mm Min./max. viscosity /conditions 100-200 mPas / at 25°C, Brookfield RVT, spindle 2/20 rpm Fully hardening/curing conditions Exclusion of oxygen and contact with metal (copper or iron ions) Min./max. initial strength 5-10 min Min./max. functional strength 30-40 min Min./max. final strength 3 h-6 h Min./max. processing temperature 5 to 35 °C Min./max. temperature conditions -55 to 150 °C Min. flashing point 90 °C Min. prevail torque 35 Nm Conditions for prevail torque DIN EN 15865 Shelf life from production/conditions 18 Month / at room temperature Solvent-free Yes Silicone-free Yes